Supervisor 2000 Installation Instructions
Page 12
For Assistance: [email protected] +1 (909) 591-8431 PUD1601R6-1
Pre-Installation Instructions
It is assumed that the Pre-Installation Checklist steps are complete.
NOTE
Side Panel Removal
1. To remove a side panel, slide the side panel up til it clears
the pins, then pull straight out [Figure 8].
1. Locate the lid screws located on the cabinet end panels as
shown in [Figure 9]. There is one lid screw per side.
2. Using a #2 Phillips head screwdriver, remove the two (2) lid
screws,
3. Gently lift the lid in an upward motion to remove.
Do not force open the side panels. Use a screwdriver to
carefully loosen any tight fitting side panels. Take care when
doing this to prevent damage to the unit. Note the location of the
side panel after removing in order to correctly secure it.
NOTE
1
2
Lid Removal
Lid Removal (Side View)
Figure 9
Side Panel Removal
Figure 8
Lid
Screw
