ADJUSTMENT
Photocells connection input with NC contact. By default, the input is set to the activation
of photocells during closing (they are not active during opening). The activation of
photocells during closing results in an immediate stop, followed byfull opening, or
PH1
preventing further closing beginning.
When setting the photocells to operate only du ring opening (section '6.
Adjustment'P7-F1) the activation ofthe photocells results in immediate tripping.
Several safety devices are connected consecutively
The output for automatic operation test
(PHOTOTESTI
of photocells, connected to
output
PH1.
The operation of the photocells is checked before movement by short-
term disconnection and then reconnection ofthe power to the photocells transmitter.
PH.T
Photocells connection diagram-tig. 26. In settings (section '6. Adjustment'
P7-F3)
the
activation of the corresponding menu option is performed. After the door closing in
standby mode, the output
'PH.T'
is turned
off.
The consumption of photocells is less
as the power of the photocell transmitter is turned
off.
At the beginning of the door
opening the output
'PH.T'
is turned on
•
Connection input of the antenna screening conductor
Connection input of the antenna signal conductor
□
The connector
(fig.
29) used to connect the 24 V DC/1.2 Ah battery.
The battery gives
the opportunity to open the door in the emergency mode (in case of supply voltage
disconnection). The full charge time ofthe battery is 48 hours
The operation of the devices is shown by LEDs
(fig.
30).
Tab/es
INDICATION DESIGNATION
ILLUMINATES
DOES NOT
ILLUMINATE
A radio control command is received (the LED shines
•
in red if the console or the remote control button is
is given
notgiven
not recorded/shines green ifthe remote control
button is recorded)
PH1
Safety device-photocells (input
'PH1
')
was activated
was
not activated
s
Safety
device-STOP
(i nput
'S')
was activated
was
not activated
SBS
command to open, stop, close (input'S8S1
is given
notgiven
&
ATTENTION!
The state of LEDs, when a command is not given, is shown in bald.
6.
ADJUSTMENT
20
The adjustment of the drive is performed using the board with buttons. A display is used for
indication
(fig.
30).
IPR./<I
IST./
►
I
IOP./AI
la../vl
the button to enter the settings menu and to exit the menu.
the button to enter the settings and confirm the selected value.
the button to move step-by-step to the menu with the zoom; it is also used to
control the opening process when setting the end positions manually.
the button to move step-by-step to menu with reduction; it is also used to
control the closing process when setting the end positions manually.
LEVIGATO DRIVES (LG SERIES) LEVIGATO ANTRIEBE (SERIE LG) COMMANDES LEVIGATO (SERIE LG)
