Verify proper operation using your FACP/burg panel installation manual.
IN
STALL
G
U I D E
I
BAT-Fire
™
Communicator
Connect Family
BAT-Fire
is a device that connects to an intrusion or fire alarm
control panel (FACP) and provides central station alarm
reporting.
Features
• Supports 12V and 24V regulated FACPs/burg panels
• Alarm capture via phone line interface or standard
FACP/burg panel points
• Supports Contact ID (CID) reporting format
• Dual Path: Ethernet (primary) with Cellular (backup)
• Sole Path: Ethernet or Cellular
• Platform visibility through AlulaConnect™
• Trouble event detection and reporting
• Four programmable input/output ports
• At-a-glance system status via front-panel LEDs
•
UL 864 10th edition commercial fire certification
•
ULC-S559 commercial fire
certification
•
UL 1610 commercial burg certification
•
ULC-S304 commercial burg certification (Security Level II
installations)
Scan QR for most up to date
manual, features, and compatibility
Operation
Phone line capture
BAT-Fire provides two PSTN interfaces for the FACP/burg panel’s DACT phone line connections.
BAT-Fire’s DACT phone interface connection provides phone line voltage, dial tone, ringback tone
and all required CID protocol signaling. The BAT-Fire receives CID events from the FACP/burg
panel’s DACT and then relays the CID events to the central station receiver.
Point capture
The BAT-Fire provides inputs that can be used to monitor an FACP’s alarm, AC fail, and trouble
points (dry contact outputs). In this topology BAT-Fire inputs will be connected to the FACP points
(dry contact outputs). BAT-Fire will continually monitor the state of the FACP points (dry contact
outputs). A state change on a BAT-Fire monitored FACP point (dry contact output) will be report-
ed to the central station. (Refer to the Programming section describing how to set-up a BAT-Fire
input for FACP point capture.)
Note:
for UL 864 10th edition,
this configuration may only be used for panels with one input zone.
9th edition and earlier permitted this method for multiple protection zones.
Central station communication
The BAT-Fire can be configured to provide dual path connectivity using Ethernet/broadband
and cell or single path connectivity using either Ethernet/broadband or cell to Bosch Conettix
D6100IPv6 receivers at the central station.
BAT-Fire, AT&T™ (BAT-FIRE-ATT)
BAT-Fire, Verizon™ (BAT-FIRE-VZ)
