ASSEMBLY AND INSTALLATION:
INSTALLATION (Fig. 2)
6.
Unscrew the
lock nuts
from the
mounting bracket
.
7.
Pull the power supply wires out from the
outlet box
, and attach the
mounting bracket
to the
outlet box
, using the
bracket mounting screws
.
8.
Strip approximately
¼” of insulation from each supply wire from the
outlet box
. Raise
the
main fixture body
to the wall, bringing the
wall plate
close to the
outlet box
.
Make the following wire connections using the
wire nuts
:
White
(neutral)
supply wire
to
White fixture wire
Black
(hot)
supply wire
to
Black fixture wire
Supply ground wire
to
Fixture ground wire
Wrap each wire connection with 5 cm / 2 in of electrical tape.
9.
Place the
wall plate
over the
outlet box
, making sure the
fixture mounting screws
feed through the holes on the
wall plate
. Adjust the
fixture mounting screws
until
they protrude out from the
wall plate
¼”. Remove the
wall plate
and secure the
position of the
fixture mounting screws
by tightening the
hex nuts
against the
mounting bracket
.
10. Carefully tuck all WIRES and
wire nuts
into the
outlet box
. Place the
wall plate
back
onto the
fixture mounting screws
, and secure it into place using the
lock nuts
.
11. After installing the fixture, caulk the upper 2/3s of the
wall plate
to the mounting
surface. Leave the bottom 1/3 un-caulked to allow for drainage of any water that might
leak into the enclosure. The manufacturer recommends a non-drying exterior caulking
material. A good example is a clear silicone rubber sealant for exterior use.
12. RESTORE POWER AT THE CIRCUIT BREAKER. Turn on the wall switch.
5
Wire
Nut
Black
Fixture
Wire
Black (Hot)
Supply Wire
Outlet
Box
White
Fixture Wire
Mounting
Screw
Mounting
Bracket
Fig. 2
Wall
Plate
Lock
Nut
White (neutral)
Supply Wire
Fixture
screw
Supply
Ground
Wire
Fixture
Ground
Wire
Hex
Nut
