NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Install the product onto on a circuit different from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes made to the electronics circuit will void this
equipment’s
compliance with Part 15 of the FCC Rules and should not be operated.
DISCLAIMER
Altair Lighting
warrants this product to be free from defects in material and workmanship
for three (3) years from the original date of purchase by the consumer. This warranty is
limited to the counter replacement at the time of purchase, with the original purchase
receipt.
Altair Lighting
will not be liable for the loss or damage of any kind, incidental or
consequential damages of any kind, whether based on warranty contract or negligence, and
arising in connection with the sale, use or repair of the product claimed to be defective.
Some states do not allow the exclusion or limitation of incidental or consequential damages
so the above limitation may not apply to you. This warranty gives you specific legal rights
and you may also have other rights, which vary from state to state. Misuse, accident,
improper installation or maintenance will also void the warranty.
•
To clean the fixture, disconnect power to the fixture by turning off the circuit breaker or
by removing the fuse at the fuse box. Wait a few minutes for the fixture to cool down.
Use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe
the glass and surface of the fixture.
•
Do not use any cleaners with chemicals, solvents or harsh abrasives. If necessary, use
a mild soap to clean off any dirt or stains.
PRODUCT MAINTENANCE:
THREE YEAR LIMITED WARRANTY
7
