TROUBLESHOOTING:
LED DRIVER REPLACEMENT:
(NOTE: Not necessary for initial installation
– only
required if the LED driver has malfunctioned.)
1. DISCONNECT POWER AT THE CIRCUIT BREAKER.
2. Remove the wall lantern from the wall and disconnect its
wires from the power supply wires.
3. Unscrew the
glass shade
from the
hood
.
4. Remove the
screws
holding the
LED plate
in place
(Fig. 2).
5. Remove the
wire nuts
from the wire connections shown
or disconnect the
quick connector
(Fig. 3).
6. Remove the
wire nuts
connecting the
driver
to the
fixture
(Fig. 4).
7. Replace the old
driver
with the new
driver
.
8. Connect the
yellow driver wire
to the
white fixture
wire
and secure using a
wire nut
. Connect the
red
driver wire
to the
black fixture wire
and secure using
a
wire nut
or reconnect the
quick connector
(Fig. 3).
SYMPTOM
PROBABLE CAUSE
SOLUTION
Lights do not come on at all. Wall switch and/or circuit breaker is off.
Turn on wall switch and/or
circuit breaker.
Lights do not come on or
flicker.
Incorrect or loose wire connections.
Access outlet box and fix wire
connections.
Light from another light source, such as a street
light or another light fixture, is shining onto the
photocell.
Eliminate the light source or
move fixture to another
location.
Component has malfunctioned.
Call Altair Lighting support.
Lights stay on through the
day (or stay on late into the
day).
Fixture may be installed in shaded area, such as
under a porch or an eave, and enough light is
shining onto the photocell during the daytime.
Relocate fixture to a well lit
area.
Fuse blows or circuit breaker
trips when light is turned on.
Crossed wires or power wire is grounding out.
Access outlet box and fix wire
connections.
Fig. 3
Fig. 4
Fig. 2
6
