33
-EN
Fader/Balance/Rear Speaker/
Subwoofer Settings
[Fad./Bal.]
is selected on the Sound Setup Menu screen.
Fader/Balance Image area
Setting the Fader/Balance
Touch the desired point within the image area, or
touch [ ] (Front), [ ] (Rear), [ ] (Left) or [ ]
(Right).
Fader:
F15 to R15
Balance:
L15 to R15
•
To reset to the initial setting (Balance: 0, Fader: 0), touch
[Center].
Rear Speaker Setting
You can set the rear speaker output to “Off.”
Setting item:
Rear Speaker
Setting contents:
On (Initial setting) / Off
Turning Subwoofer ON/OFF
If an optional subwoofer is connected to the unit, make the
following setting.
Setting item:
Subwoofer
Setting contents:
On / Off (Initial setting)
Time Correction Settings
[
Time Correction
] is selected on the Sound Setup Menu
screen.
Before performing the following procedures, see “About
Time Correction” (page 36).
Correction mode
Setting item:
Time Correction
1
Touch the Correction mode button, and then
select [ms], [cm] or [inch].
2
Touch [ ] or [ ] for each speaker to adjust
the time or distance.
0.00 msec to 20.00 msec (0.02 msec/step)
0.0 cm to 680.0 cm (0.68 cm/step)
0.0 inch to 268.0 inch (0.268 inch/step)
All speaker setting values are adjustable in the range of
20.0 ms, 680.0 cm or 268.0 inch.
3
To store the adjusted setting value, touch and
hold [Preset 1], [Preset 2], or [Preset 3] for at
least 2 seconds.
•
Touch [
Flat
] to set all values to 0.0.
•
If the Rear Speaker setting is [
Off
], the Rear Speaker setting
cannot be edited (page 33).
•
If the Subwoofer setting is [
Off
], the Subwoofer setting cannot
be edited (page 33).
Calling the Time Correction Value
Calling the pre-set time correction value.
Touch [Preset 1], [Preset 2], or [Preset 3] on the time
correction screen.
The setting stored in the Preset will be recalled.
