64
-EN
To prevent external noise from entering the audio system.
•
Locate the unit and route the leads at least 10 cm away from the car harness.
•
Keep the battery power leads as far away from other leads as possible.
•
Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•
If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors, contact them for further information.
•
Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Installation and Connections
1
Antenna Receptacle
Connect to the supplied ISO antenna convertor plug.
2
Remote Control Input Lead (White/Brown)
Connect the external Alpine product to the remote control
output lead.
3
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular
phone which provides ground shorting when a call is
received.
4
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
5
Dimmer Lead (Orange)
This lead may be connected to the vehicle’s instrument
cluster illumination lead. This will enable the vehicle’s
dimmer control to dim the backlighting of the unit.
6
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse
box or another unused power source which provides (+) 12V
only when the ignition is turned on or in the accessory
position.
7
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
8
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
NOTE
This lead should be used only for controlling the vehicle's power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
9
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's
battery.
p
Fuse Holder (10A)
q
ISO Power Supply Connector
w
External Remote
Use when applying the separately sold remote control sensor
unit.
e
Steering Remote
To remote control interface box.
r
Digital Output Terminal (Optical)
Use when combining fiber digital input compatible products.
t
System Switch
When connecting a processor using Ai-NET, place this
switch in the EQ/DIV position. When no device is
connected, leave the switch in the NORM position.
NOTE
Be sure to turn the power off to the unit before changing the
switch position.
y
Power Supply Connector
u
Ai-NET Connector
Connect this to the output or input connector of other
product (CD changer, Equalizer, etc.) equipped with Ai-
NET.
i
DC/DC Converter
NOTES
•
Do not install the converter at a location subjected to water
such as under the floor mat or air conditioner. This may cause
a malfunction.
•
Do not bundle the DC/DC converter cable with other audio
cables. Doing so may induce noise into your system.
•
Keep the DC/DC converter away from the Antenna cables and
the rear side of the unit, otherwise noise may be generated
when receiving radio broadcast.
o
Ai-NET Cable (Included with CD Changer)
;
Front Output RCA Connectors
RED is right and WHITE is left.
a
Rear Output RCA Connectors
RED is right and WHITE is left.
s
Subwoofer Output RCA Connectors
RED is right and WHITE is left.
d
Audio Output Connectors
RED is right and WHITE is left. Output the audio.
f
Video Output Connectors (Yellow)
Output the video.
g
RCA Extension Cable (Sold Separately)
Содержание DVA-7996R
Страница 69: ......
