Alpine DVA-7996R, Руководство пользователя

Страница: 36 / 69

34
-EN
DVD/Video CD Operation
Joystick
•
DVD and video CD operations can be performed
from both the remote control unit and the main
unit (except for some operations). This section
mainly describes operations from the remote
control unit. For instructions on operating using
the buttons on the main unit, see page 48.
•
A separately sold monitor is required to view
DVDs and video CDs.
•
Play Position Memory Function:
Even if you turn power off or switch the Ignition
Key to OFF during playback or change the source,
playback will continue from the point where
playback stopped when the power is turned ON
again.
•
The DVA-7996R distinguishes the recording type of
the loaded disc, and switches the picture output
signal (NTSC or PAL) automatically. For how to
switch NTSC/PAL on the connected monitor, see
the instruction manual of the monitor.
0 ~ 9
ENTER
SOURCE
Playing DVD/Video CD
• With some DVDs, certain operations
are disabled. Such operations are not
possible on such DVDs.
• The DVD functions described in this
manual are not supported by all
DVDs. See the individual DVDs
instructions for details on the features
supported.
• Fingerprints on a disc may adversely
affect playback. If a problem occurs,
remove the disc and check for
fingerprints on the playback side.
Clean the disc if necessary.
• When using the remote control, be
careful to press one button at time.
Pressing multiple buttons at the same
time may cause erroneous operation.
• Even if you switch the power or the
Ignition Key to OFF during playback or
change the source, playback will
continue from the point where it stopped
when the power is turned ON again.
• Operation may not be accepted
depending on the type of disc and the
playback conditions. At such a time
the following mark is displayed on the
monitor screen:
DVD
Video CD
Caution
• When using the remote control unit
To operate a DVD or video CD, set the
selector switch on the rear of the remote
control unit to the “AUDIO” side.
Tips
These indicate the discs for
which the function can be used.
Stopping playback (PRE-STOP)
Press the stop button during playback to stop
playback. That position is stored in the memory.
1
Press the button once during playback.
“PRE-STOP” is displayed.
DVD
Video CD
DVD
..
.DVDs
...
Video CDs
Video CD
• Reading this manual
1
Press the button on the main unit.
The movable display will open.
2
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
The movable display will close and playback will
begin.
When a disc is already inserted, press the
SOURCE button to switch to the disc mode.
The mode will change every time the button is
pressed.
Insert a disc with the label side facing up.