SEED-DRILLSSEMINATRICE PNEUMATICA JET-M
Old Cod.Q00A00168
New Cod. MANT2018/00060 R.2
INSTALLATION
- 17
Copyright ©2009 della Alpego srl ® -Tutti i diritti sono riservati. È espressamente vie
tata la ristampa o l’uso non autorizzato per iscritto da parte di Alpego srl
Follow these instructions:
1.
In order to use correctly the “ALPEGO” hitching/unhitching method,
make sure that the seed-bar is securely standing on its legs.
2. Shorten the tie-rods
A
, so as to lift the hitching holes
B
of the
parallelograms.
3. Move the machine close to the seed-bar, and be careful to fit
correctly the hooks
C
into the holes
B
.
4. Lift the machine and hitch the seed-bar until you slightly lift it.
5. Once the combination has been completed, lock the quick-hitch with
the screws
D
.
6. Bring the supporting legs into the working position.
4.5. ASSEMBLY OF THE REAR LIGHTS
When the seed-drill JET-X is delivered, the plates with the rear lights and their
supports are supplied unassembled and they are to be found inside the
hopper.
The electric wiring is already in place on the seed-drill-bar.
To assemble the rear lights proceed as follows:
1. Place the two supports
A
on the two ends of the upper tube of the
seed-drill-bar and fasten them by means of their U-Bolts
2.
Mount the plates
B
on the supports
3.
Connect the electric wires of the lights with the already assembled
electric wiring on the seed-drill-bar.
