SEED-DRILLSSEMINATRICE PNEUMATICA JET-M
Old Cod.Q00A00168
New Cod. MANT2018/00060 R.2
INSTALLATION
- 16
Copyright ©2009 della Alpego srl ® -Tutti i diritti sono riservati. È espressamente vie
tata la ristampa o l’uso non autorizzato per iscritto da parte di Alpego srl
4.4.2. ASSEMBLY OF THE SEED COVERING HARROW
At the time of delivery of the Seed-drill JET-M the following harrow is supplied in the shipment position.
In order to position it correctly follow this instructions:
1. Remove the pins
A
and
B
, rotate the tube with the springs (1) and, at the same time, lower the complete following
harrow (2) to the ground.
2. Place again the pins
A
into 1 of the 4 holes in the bracket to prevent the rotation.
3. Rotate the lever
C
to make the assembly of the loading spring
D
easier. Make sure that the spring maintains a slight
tension even in the lowest working position, so as to prevent an accidental unhooking.
4. Lift the following harrow and position the pins
B
in the perforated sections under the arms supporting the following
harrow. The position of pin
B
changes the pressure of the tines of the following harrow.
Never place the pins B in the holes above the supporting tube in order to stop its oscillation: while
working structural damages to the arms may occur.
4.4.3. HITCHING THE SEEDING BAR 400
Before you hitch the seed-bar, make sure the parallelograms are mounted in their correct position. The position varies depending
on the type of rear roller of the machine
.
POSITION 1 - ROLLERS SERIES 5
POSITION 2 - ROLLERS SERIES 6
After the parallelograms have been mounted in their correct position, it is possible to hitch the seed-bar.
