Alltech 30L100, Руководство оператора

Страница: 26 / 77

KEENAN MechFiber300 Operator’s Manual
26
Revision F01 06
th
March 2020
Model MechFiber300
Primary Drive Chain ASA 100
Links 104 (inc. joiner)
Pitch (mm) 31.75
Pitch (inches) 1.25
Chain length (mm) 3,302
Chain length (inches) 130
Rotor Drive Chain ASA 140HS
Links 114 (inc. joiner)
Pitch (mm) 44.45
Pitch (inches) 1.75
Chain length (mm) 5,067.3
Chain length (inches) 199.5
Table 4: KEENAN MechFiber300 drive chains
8.3 Greasing
1. Bearings : Each week, apply grease to the eight bearings with grease fittings. The
bearings are as follows:
a. The main rotor bearing at the front of the KEENAN MechFiber (A, Figure 10a).
b. Two main bearings on the front and rear of the input drive shaft (B1 and B2, Figure
10a).
c. The auger bearing and idler shaft bearing at the front of the KEENAN MechFiber (D1
and D2, Figure 10a).
d. The bearing on the rear of the idler shaft (F, Figure 10a).
e. Two main bearings at the rear of the KEENAN MechFiber (G and H, Figure 10b).
2. Grease Fittings : Each week apply grease to the following points with grease fittings
(there are up to 26). The points are as follows:
a. Two pins and two bushes on the guillotine door lifting rams (I, J, K and L, Figure 11)
b. 18 grease fittings on the tandem axle assembly (where fitted):
Two on each brake rod, one on each pivot (eight in total)
One on each brake arm (four in total)
One on each front spring pin (four in total)
One on each centre spring assembly pivot (two in total)
c. Three grease fittings on the tension arms:
One on the secondary chain tension arm (E, Figure 10a)
Two on the primary chain tension arm (C1 and C2, Figure 10a)
(also: see Figure 12)
d. See Section 8.4 for Bale handler maintenance details.
e. Grease fitting in pivot bush on gearbox pin.
3. VFC-Door : Check the VFC-Door is able to move freely each day and grease as
appropriate.