Alltech 30L100, Руководство оператора

Страница: 11 / 77

KEENAN MechFiber300 Operator’s Manual
11
Revision F01 06
th
March 2020
p) Standing level with or above the machine in order to load manually is not permitted.
Loading should only be carried out with suitable equipment.
q) Regularly inspect all chains (at least weekly), sprockets and moving parts for wear and
check all nuts and bolts for tightness.
r) The ladder on the rear of the Diet feeder is to be used as a viewing point for the mixing
chamber. It should not be used as a means of access to the mixing chamber nor onto
the body of the machine. It is strictly forbidden to climb on the upper rim of the machine
body. The height of the machine presents a potential fall hazard during entry and exit.
s) The noise emission level of the MechFiber300 has been recorded at 89.4dB. Noise
emission levels above 90dB would require the wearing of suitable ear protection.
t) The Breakaway Safety Brake device should be attached to the tractor at all times
.
Cable
ties fix the wire rope along the handbrake handle in place. Cable tie the wire rope to the
drawbar (see Figure 4). Fix the other end of the wire rope to a solid location on the back
of the tractor e.g.: using the top link pin. In the event that the Breakaway Safety Brake
device has been activated or damaged, it is recommended that KEENAN is contacted
for directions to reset.
u) Routine cleaning may be carried out using a power washer. Isolate any power sources
before beginning. If washing the inside the Mixing Chamber, open the drain bung
underneath the body to allow water escape. Always disconnect PTO shaft from the
tractor and stand on suitably safe ladder or platform. Do not to climb on top of machine
or into the Mixing Chamber.
v) It is recommended that only KEENAN-trained and qualified maintenance
personnel enter the mixing chamber.
In the case of an untrained person entering the mixing chamber, at the very minimum,
the following precautionary safety guidelines should be strictly adhered at all times.
1. Ensure the PTO and hydraulic hoses are disconnected.
2. Apply the Diet feeder handbrake and disconnect the tractor from the machine on
level ground.
3. Use suitable PPE such as protective footwear, eye wear and gloves.
4. Personnel should make themselves familiar with the location of all potential
hazards before entering the machine, in particular the location of the top knife and
body blades.
5. Be aware that sharp components may be hidden in or under material within the
mixing chamber.
6. The top knife should always be fitted with the supplied guard (Figure 3b) before
entering the machine. Begin by fitting the first 500mm of guard from the rear of the
machine. Then as you enter continue to fit the guard along the full length of the
Top Knife.
Note: the machine is supplied with a top knife guard which can be found inside the
driveline covers of the Diet feeder
7. Use a suitable and secure ladder for access to and from the Diet feeder.
Note: The ladder at the rear of the machine is provided as a means of viewing the
ration only and should not be used as a means of access the mixing chamber.
8. Always maintain three points of contact while entering, exiting and moving within
the mixing chamber of the machine.