Alltech 30L100, Руководство оператора

Страница: 10 / 77

KEENAN MechFiber300 Operator’s Manual
10
Revision F01 06
th
March 2020
The following safety points are general guidelines. Given the wide variety of possible operating
conditions other safety risks may exist which are not captured in the list over.
a) Always park the Diet feeder on level ground and apply the handbrake when not in use.
b) Do not exceed 15 km/h (10 mph) when in use/transit. Local road traffic laws will apply
when the machine is in transit on public road, on which the maximum permissible speed
is 25 km/h. Exceeding this will compromise the life and safety of major components such
as the hitch, axle, wheels and chassis.
c) Ensure the VFC-Door is closed and all Feed-Out Trays/Elevators are in the closed and
transport position prior to use on the public road.
d) Exercise extreme caution for possible overtaking traffic at either side when turning.
e) Do not stand on the ladder while the feeder is in transit. The Diet feeder should never
be used for the transport of people, animals or objects.
f) Do not stand between the tractor and Diet feeder while it is in use.
g) Use only a PTO shaft with a properly fitted safety guard and correct shear bolt.
h) Always connect the PTO shaft with the shear bolt end to the machine. The operating
speed of the PTO is 540 rpm and the direction of rotation is marked on the front cover.
Always use a well maintained PTO shaft and keep the safety covers in good condition.
i) Ensure all trailing leads, hoses, etc. are well clear of the PTO.
j) Never operate the PTO in
“ground speed mode” or drive the PTO in reverse.
k) Make sure all covers/guards are fitted and closed correctly. Never remove guards when
the Diet feeder is connected to the tractor.
l) Ensure the Diet feeder and the immediate area surrounding it is clear of people,
especially children, before commencing operation. Ensure that there is sufficient
visibility for the operator to observe all danger zones and that the tractor is equipped
with mirrors to enable the operator to see both sides of the machine while it is in
operation.
m) When connecting the tractor to the Diet feeder only connect using the ring hitch/hitch on
the Diet feeder to ensure safe coupling. Ensure that the hitch is connected properly to
the tractor and that all pins and clips are properly installed. Then connect the PTO shaft
in the correct fashion. Connect the hydraulic hoses ensuring that the functions match
the indicated valve on the tractor.
n) When disconnecting always ensure that a stand or jack is used to secure the Diet feeder
in the park position and ensure that the handbrake is properly applied. Before driving
the tractor away from the Diet feeder ensure that all hoses and cables are disconnected.
o) Load only from the side indicated
– see Figure 7 (auger chamber side), using suitable
equipment.