Allmatic INVERTER COMPACT, Инструкция

Страница: 13 / 20

6-1622616 /R0 06/10/2017
13 / 20
High Speed CL
OK → →
NNNHz
Regulation of the normal speed of the gate during the closing phase
speed expressed in Hz (frequency of the wave supplied to the motor)
Low Speed CL
OK → →
NNNHz
Regulation of the speed of the gate during the closing phase when approaching
the end of the run
speed expressed in Hz (frequency of the wave supplied to the motor)
High Torque OP
OK → →
NNN%
Torque supplied to the motor during the opening phase at normal speed
percentage of torque supplied to the motor (000%...100%)
Low Torque OP
OK
→ →
NNN%
Torque supplied to the motor during the opening phase when approaching the
end of the run
NNN: percentage of torque supplied to the motor (000%...100%)
High Torque CL
OK → →
NNN%
Torque supplied to the motor during the closing phase at normal speed
percentage of torque supplied to the motor(000%...100%).
Low Torque CL
OK → →
NNN%
Torque supplied to the motor during the closing phase when approaching the
end of the run
percentage of torque supplied to the motor (000%...100%).
EXIT
OK
→ →
4.5 Programming menu C (key P3) - List of parameters
The following table lists the entries of menu A and reports a short description of the parameters that can be adjusted; refer to paragraphs dedicated to
each function for more information
MENÙ C Display
Language
OK → →
Select the language (where applicable)
Backlight
OK
→ →
OFF
ON
Backlighting of the display
the light of the display is disabled
the light of the display is enabled and its automatic switching-off is timed
(Energy saving)
Reset
OK → →
Total reset of factory settings of the control board.
WARNING: all programming operations and the setting of the control board must
be repeated after this operation
EXIT
OK → →