Allmatic INVERTER COMPACT, Инструкция

Страница: 4 / 20

6-1622616 /R0 06/10/2017
4 / 20
1. INTRO
The control unit INVERTER COMPACT is integrated in the motor KALOS XL . It is a device suitable for operating and controlling the sliding gate in a way
easy and complete; it is designed in order to satisfy all possible needs.
The inverter on board allows to set the maximum torque limits along with the possibility to modify the frequency (the speed of the motor).
The possibility to use motors with encoder allows the unit to detect possible obstacles along the run and reverse its direction of motion. It is suitable to
command and control automatics accesses equipped with three-phase motors 230/400Vac delta-connected max 1,5KW (current limited to 10A). Every
control board is equipped with a memory module that stores all personal settings and parameters needed for operating the control board (these data
can be transferred from one unit to another one). It is equipped with inputs for self-tested photocells, keys for SS (step-by-step), PED (partial opening),
OPEN and CLOSE, switch limits, security stops and a wide display with 3 keys for settings. It is also equipped with a molex connector for a plug-in
receiver, output for courtesy and flashing light. It is possible to connect an additional card (R1) to operate an electric lock.
WARNING: DO NOT INSTALL THE CONTROL UNIT WITHOUT READING THE INSTRUCTIONS FIRST!
- Make sure you have installed the electric limit switches and to correctly adjusted them.
Note: To use the obstacle detection function, a compatible encoder must be installed first
Fuses Fuses features:
F1: Protection line 230V T 10A
F2: Input protection F 250mA
F3: Photocells protections F 250mA
F4: 24Vac auxiliaries protection F 500mA
For the connection of the motor we recommend to use a screened cables 3 poles + earth 1.5 mm2 (type FD781CY)
For the connection of the possible encoder we recommend to use a screened cable 3 x 0,75mm2 (type OLFLEX-110CH)
NOTE: Inputs EDGE, PHOTO and STOP normally closed (NC), if not used, must be excluded trought related dip switches. Set the dip corresponding to
the unused input to ON.
WARNING! Before activating the installation, make sure that the installed safety devices are functioning properly.
It is FUNDAMENTAL to connect the motor and the unit to the EARTH in order to operate the control unit correctly! In case an encoder is applied, it is
compulsory to use a shielded cable with the screening connected to the EARTH only by one end of the cable itself.
WARNING!! DELTA CONNECTION OF THE MOTOR IS REQUIRED.
Technical features of control unit INVERTER COMPACT
Input power supply 230 Vac +15%, -15% ; 50Hz single-phase
Photocells power supply 24 Vdc 5W MAX
Accessories power supply 24 Vac 10W MAX
Motor output 230 Vac three-phase 1,5KW Max (current limited at 10A), cosF > 0.8
Flashing light output 230 Vac 60W MAX for FIX light, without flashing circuit
Courtesy light output 230Vac 100W MAX
Elettrobrake / Electrical lock output 250Vac 16A Max, 24Vdc 16A Max