Allmatic INVERTER COMPACT, Инструкция

Страница: 12 / 20

6-1622616 /R0 06/10/2017
12 / 20
Clock
OK → →
OFF
ON
Programmed opening function
disabled
the gate opens and stays open until the OPEN input is active
Water Hammer OP
OK → →
OFF
XX,Xs
Water hammer before the gate opens
disabled
enabled. Adjustment of pressure time (in seconds) applied to the mecha-
nical stop in closing
Encoder
OK → →
OFF
ON
Functioning with encoder (only for motors equipped with a suitable
encoder)
disabled
enabled (WARNING: the re-programming of the runs is needed)
Sensor Level
OK → →
OFF
NNN
Level of operation of the “motor still sensor” (with active encoder only)
sensor disabled
sensor enabled - adjustment of operation’s sensitivity
Sensor Inv
OK → →
OFF
ON
Modality of operation of the “motor still sensor” (with active encoder only)
the gate stops
reverses shortly in opening; opens completely in closing
EXIT
OK
→ →
4.4 Programming menu B (key P2) - List of parameters
The following table lists the entries of menu A and reports a short description of the parameters that can be adjusted; refer to paragraphs dedicated to
each function for more information
MENÙ B Display
Manual Motion
OK → →
Allows to move the gate at low speed by using the keys located on the control board.
This function is fundamental in order to check the motion during the installation
End Position
OK
→ →
Learning the full run of the gate, both in opening and in closing
WARNING: this operation must start when the gate is completely closed
Ped. Position
OK → →
Learning of the opening partial position
WARNING: this operation must start when the gate is completely closed
High Speed OP
OK
→ →
NNNHz
Regulation of the normal speed of the gate during the opening phase
speed expressed in Hz (frequency of the wave supplied to the motor)
Low Speed OP
OK → →
NNNHz
Regulation of the speed of the gate during the opening phase when approaching
the end of the run
NNN: speed expressed in Hz (frequency of the wave supplied to the motor)