Allmatic INVERTER COMPACT, Инструкция

Страница: 6 / 20

6-1622616 /R0 06/10/2017
6 / 20
11-15
OPEN INPUT
Connect the button OPEN between the clamps 11 and 15 of the
terminal board. ATTENTION: leave it open if not used
12-15
CLOSE INPUT
Connect the button CLOSE between the clamps 12 and 15 of
the terminal board. ATTENTION: leave it open if not used
13-15 PARTIAL OPENING INPUT
Connect the PARTIAL OPENING button (PED.) between the
clamps 13 and 15 of the terminal board. ATTENTION: leave it open if not use
14-15 STEP BY STEP INPUT
Connect the STEP-BY-STEP BUTTON (S.S.) between the clamps
14 and 15. Under the dead man mode the STEP BY STEP BUTTON operates
as OPEN.
ATTENTION: leave it open if not used
16-17-18
MOTOR OUTPUT
Connect the three phases of the motor in the terminals 16-17-
18 (M2)
WARNING!! THE MOTOR MUST BE CONNECTED AS
TRIANGLE / DELTA MODE Δ
Only for stand alone connection
For the connection of the motor we recommend to use a
screened cables 3 poles + earth 1.5 mm2 (type FD781CY)
Before activating the automation make sure that all the safey
devices are correctly cabled and functioning, refer to the
preliminary checkings
WARNING! Risk of electric shock
19-20
COURTESY LIGHT
Connect the courtesy light to the clamps 19 and 20, 230Vac
100W MAX. It is possible to light up the action area of the
automatism during each motion.
The functioning of the auxiliary light is controlled by the MENU
A [P1].
21-22
FLASHING LIGHT
Connect the flashing light to the clamps 21 and 22 [M2]. Use a flashing light without self flashing card 230Vac 60W MAX
23 Ground connection
24-25
POWER SUPPLY
Connect the power supply cable between the terminals 24
and 25.
Use a cable with an adequate section based on the current
absorbed by the motor Do not connect the card directly to the electric network. Put a
device which can ensure the disconnection of each pole from
the power supply of the control unit.
26-27-28
ELECTRICAL BRAKE / ELECTRICAL LOCK power supply
Connect the ELECTRICAL BRAKE / ELECTRICAL LOCK between
the terminals
26-27
if needs of normally closed dry contact
(16A MAX)
Connector
E
ENCODER INPUT
Connect the encoder to the control unit on the specific
connector The activation / deactivation of the encoder functions is mana-
ged in the MENU A