Allmand Maxi-Power MP65 T4F, Руководство оператора

Страница: 51 / 76

Not for
Reproduction
51
Periodic Inspection
63
Change Fuel Filter Element
Every 250 Hours
B
A
<Procedure>

Take out the filter case [A] using a filter wrench.

After thinly applying fuel on the new gasket [B], screw
it
in.

After the gasket touches the sealing face, tighten
another 2/3 turn with a filter wrench.

Bleed air from fuel.

After installing the fuel filter, check it for any leaks
during operation.
Change Pre-filter Element
Every 500 Hours
<Procedure>
1. Loosen the drain plug [A] and air bleeder plug [B] to
discharge the fuel inside the filter. After draining
completed, tighten the plugs [A] and [B] securely.
2. Use the special filter wrench to remove the filter
case [C].
3. Replace the O-ring with new one and place new
element [D] in the case. Thinly apply the fuel on the
O- ring, and screw in the element.
4. After the O-ring contacts seal surface, tighten the case
with the filter wrench.
5. Remove the air from fuel. See "Fuel Line Air Bleeding
Device" in the Operation section.
Clean Radiator
Every 500 Hours
<Procedure>

If the fin tubes [C] are clogged by dust or other foreign
materials, the heat exchange efficiency drops and this
will raise coolant temperature. These tubes and fins
should be cleaned depending on the state of dirt inside
the tubes even before maintenance schedule.

Do not use high pressure washer for cleaning as it may
damage fin tubes.

When the unit is used or installed near seaside or
onboard a boat, clean the radiator using fresh water at
least once a month.
A
B
C
B
D
E
C
A