Allmand Maxi-Power MP65 T4F, Руководство оператора

Страница: 28 / 76

Not for
Reproduction
28 ALLMAND.COM
Operation
36
Clean Inside Control Panel
A080239-1

Before starting operation, open control panel and check each
breaker, terminal plate and each controller for any dust, sand and
dirt accumulated.

If the machine is operated with dust, sand, or dirt in the
instrumentation, it could cause malfunction or damage. When
necessary, clean the inside of the panel with compressed air.
Wear protective eyewear when cleaning.
Check and Adjust Belt Tension
Press the center
A180780
<Procedure>
1. Visually check there are no cracks or wear or other damage to
the belt.
2. Belt tension is adjusted by loosening the alternator mounting
bolts and nuts. While pressing the center of the belt slightly,
adjust belt tension by loosening fitting bolt so the amount of
deflection is between 6.6 and 7.4 mm at 98 N ewtons (N) .
3. If there is any oil or coolant on the belt, wipe it off completely
during service.

Refer to engine instruction manual for more details for belt
adjustment.
A010011

Be sure to stop the engine and remove the starter key whenever
the tension of the belt is to be adjusted

If the machine is in operation, it might catch the operator’s hand
into the belts, and this could cause a serious injury

Over-tensioning of the belt leads to shaft breakage and reduced bearing life. If it is too loose, belt
slippage may lead to premature breakage of the belt or damage to the machine due to overheating.
Amount of deflection
6.6 – 7.4 mm @ 98 N