Allmand Maxi-Power MP65 T4F, Руководство оператора

Страница: 32 / 76

Not for
Reproduction
32 ALLMAND.COM
Operation
40
Auto Start
1. Cable connection method of remote control switch.

The remote control terminal [J] is provided inside the output terminal. Perform cable connection as
shown below for remote control operation of the machine. For this cable connection job, make sure to
remove the battery cathode cable terminal.
<Procedure>
1. Perform manual start to adjust voltage, stop the engine.
2. Push the auto mode button [H].
3. Set the circuit breaker [J] to [ON] position.
4. Setting remote control terminals [A1-A2] to [ON] starts the engine.
(In cold conditions, pre-heating starts automatically. After glow lamp [E] is switched off, the engine
starts.)
5. Setting remote control terminals [A1-A2] to OFF stops the engine.
Inspection and maintenance prohibited during automatic
operation

Never put your hands close to the interior of the machine,
because the generator can begin operation without warning
even while the machine is set to the stop position.

Before starting inspection and maintenance job, make sure to
hang the tag “Under inspection and maintenance”.

Remove the battery cathode cable terminal.
Install the battery charger

While the unit is in stand-by conditions during automatic operation, battery discharge occurs. Make sure
to charge battery, operating the battery charger.
Terminal Plate
Cable Connection to
be done by
Customer/user.
In case
customer/user
performs
Battery
J