Allied Vision Goldeye CL Series, Техническое руководство

Страница: 249 / 254

Cleaning optical components
249 Goldeye G/CL Technical Manual V4.2.0
1. Unplug the camera from any power supply before cleaning.
2. Have the cleaning materials ready before you start the cleaning.
3. Apply a small amount of cleaning liquid to a clean, new lens cleaning pad or
tissue.
The pad or tissue should be moist, not dripping. Hold the camera away from
your body to avoid particles like skin flakes from falling onto the sensor. The
camera front should point roughly 45 degrees upwards.
4. Wipe the surface in either one of two ways described to ensure any dirt
present on the surface be moved to the edge of the surface:
-
With a spiral motion from the center to the rim. Normally, several spiral
wipes are recommended. Wipe only on sensor or optical filter avoiding
contact to metal surfaces, because microscopic dirt could be released and
could cause scratches on the optical filter or sensor.
- With a straight motion across the optical filter or sensor surface from one
end to the opposite end.
5. When you've finished cleaning, examine the surface in a bright light. Take an
out-of-focus picture of a flat, illuminated surface to see if any dirt or dust
remains.
6. If dust spots remain, repeat this procedure once, using new clean lens tissue
(as described).
Figure 81: Lens cleaning tissues and cleaning pads
Figure 82: Use of cleaning tab or tissue to clean a sensor
If dust spots remain
If dust spots remain after cleaning twice, contact your Allied Vision distribution
partner.