C613-50066-01 REV A
Command Reference for IE200 Series Industrial Managed PoE+ Switches
601
AlliedWare Plus™ Operating System - Version 5.4.5I-0.x
S
TATIC
R
OUTING
C
OMMANDS
FOR
M
ANAGEMENT
P
URPOSES
IP
ROUTE
ip route
Overview
This command lets you creates a static route, in order to send management
packets to the appropriate VLAN.
Your switch does not use static routes to route traffic from one VLAN to another
VLAN, even if the VLANs have IP addresses. You cannot create static routes to route
data, only management packets.
The
no
variant of this command removes the static route.
Syntax
ip route
<subnet&mask>
{
<gateway-ip>
|
<interface>
}
[<distance>]
no ip route
<subnet&mask>
{
<gateway-ip>
|
<interface>
}
[<distance>]
Mode
Global Configuration
Default
The default administrative distance for a static route is 1.
Example
To send management traffic on the 10.0.0.0 network to vlan10 and other
management traffic to vlan5, use the commands:
awplus#
configure terminal
awplus(config)#
ip route 10.0.0.0/8 vlan10
awplus(config)#
ip route 0.0.0.0/0 vlan5
Related
Commands
show ip route
show ip route database
Parameter
Description
<
subnet&mask
>
The IPv4 address of the destination subnet defined using either a
prefix length or a separate mask specified in one of the following
formats:
The IPv4 subnet address in dotted decimal notation followed by
the subnet mask, also in dotted decimal notation.
The IPv4 subnet address in dotted decimal notation, followed by a
forward slash, then the prefix length.
<
gateway-ip
>
The IPv4 address of the gateway device.
<
interface
>
The VLAN interface that the target packets should be sent to. Enter
the name of the VLAN or its VID.
The gateway IP address or the interface is required.
<
distance
>
The administrative distance for the static route in the range
<
1-255
>. Static routes by default have an administrative distance
of 1.
