Allied Telesis AT-ANC10S, Инструкция по установке и эксплуатации

Страница: 97 / 124

AT-ANC10S/2 Adapter Installation and User’s Guide
97
Solving Microsoft Windows Server 2008 R2 Hyper-V Issues
Microsoft Windows Server 2008 R2 Hyper-V™ is a hypervisor
virtualization system. For detailed information about Hyper-V, refer to the
following website:
www.microsoft.com/windowsserver2008/en/us/hyperv.aspx
This section addresses issues that affect the configuration of the
AT-ANC10S/2 network adapter and teamed adapters when Hyper-V is
used.
Note
Ensure that Integrated Services, which is a component of Hyper-V,
is installed in the guest operating system (child partition) for full
functionality.
Single Network
Adapter
When configuring an AT-ANC10S network adapter for Hyper-V, be aware
of the following:
 An adapter that is bound to a virtual network should not be
configured for VLAN tagging through the driver's advanced
properties. Instead, Hyper-V should manage VLAN tagging
exclusively.

Since Hyper-V does not support Jumbo Frames, it is
recommended that this feature not be used or connectivity issues
may occur with the child partition.
 The Locally Administered Address (LAA) set by Hyper-V takes
precedence over an address set in the adapter's Advanced
Properties.
 In an IPv6 network, a team that supports Checksum Offload (CO)
and Large Send Offload (LSO) and is bound to a Hyper-V virtual
network reports CO and LSO as an offload capability in BACS.
Also, in an IPv6 network, a team that supports CO or LSO and is
bound to a Hyper-V virtual network reports CO or LSO as an
offload capability in BACS. However, in both instances CO and
LSO do not work. This is a limitation of Hyper-V because this
system does not support CO and LSO in an IPv6 network.