Allied Telesis AT-ANC10S, Инструкция по установке и эксплуатации

Страница: 68 / 124

Chapter 6: Setting Advanced Properties
68
Jumbo Packet Enables the network adapter to
transmit and receive oversized
Ethernet frames that are greater
than 1514 bytes, but less than or
equal to 9000 bytes in length
(9600 bytes for network adapters
that operate at 10 Gbps). This
property requires the presence of
a switch that is able to process
jumbo frames. This property is
only available for the
AT-ANC10S/2 network adapter.
Frame size is set at 1500 bytes by
default. To increase the size of the
received frames, raise the byte
quantity in 500-byte increments. 1. In Microsoft Windows,
right-click the Network Adapter
in Network Connections, and
then click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Enter the desired Jumbo
Packet value.
Large Send Offload
v2 (IPv4) Normally, the TCP segmentation is
done by the protocol stack. When
you enable the Large Send
Offload property, the TCP
segmentation can be done by the
network adapter. The default
setting for this property is Enabled.
This property is only available for
the AT-ANC10S/2 network
adapter. 1. In Microsoft Windows,
right-click the Network Adapter
in Network Connections, and
then click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Select the desired Large Send
Offload v2 (IPv4) value.
Large Send Offload
v2 (IPv4) Normally, the TCP segmentation is
done by the protocol stack. When
you enable the Large Send
Offload property, the TCP
segmentation can be done by the
network adapter. The default
setting for this property is Enabled.
This property is only available for
the AT-ANC10S/2 network
adapter. 1. In Microsoft Windows,
right-click the Network Adapter
in Network Connections, and
then click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Select the desired Large Send
Offload v2 (IPv6) value.
Table 8. Advanced Features in Microsoft Windows
Feature Description Configuration Steps