ALLIANCE Automaatic washer, Руководство по установке и эксплуатации

Страница: 12 / 32

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
210193 10
Before You Start
Tools
For most installations, the basic tools you will need
are:
Figure 1
Electrical
Refer to Serial Plate for specific electrical requirements.
For more detailed information refer to section on
Electrical Requirements .
Water
Washer needs two standard 19.1 mm (3/4 inch) water
supply faucets with a pressure between 1.4 and 8.3 bar
(20 and 120 pounds per square inch). For more
detailed information refer to section on
Water Supply
Requirements .
Installing the Washer
Step 1: Remove the Shipping Brace and
Shipping Plug
NOTE: Install dryer before washer. This allows
room for attaching exhaust duct.
Remove the shipping brace from under the lid. The
plastic shipping plug will be released from the base of the
washer when removing the cardboard base from the
washer.
IMPORTANT: The shipping brace and plug should
be saved and must be reinstalled whenever washer
is moved or transported to a new location. This will
prevent damage to washer components. Do not tilt
washer to front or sides when moving.
Refer to Maintenance section for instructions on
reinstalling shipping brace and shipping plug.
Figure 2
D074I
1 Wrench
2 Screwdriver
3 Pliers
4 Level
D074I
1
2
3
4
TLW521N
1 Shipping Brace
2 Shipping Plug
1
2