ALLIANCE Automaatic washer, Руководство по установке и эксплуатации

Страница: 18 / 32

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
210193 16
Step 6: Plug In the Washer
Refer to section on Electrical Requirements , and plug
the washer in.
Figure 14
Step 7: Add Water to the Washer
To prevent damage to pump, do not run washer before
adding at least one quart water to the tub. If the washer
is run before any water is added, the pump seal may
overheat causing the pump to leak. Once installed, the
water retained in the drain system from the previous
cycle will provide sufficient cooling to prevent pump
seal damage.
NOTE: The agitator should not be removed except
for service. The washtub is designed to be self-
cleaning.
Figure 15
Step 8: Check Lid Switch
Washer should stop agitating and spinning when lid is
opened.
Figure 16
Step 9: Check Installation
Refer to Installer Checklist on the back cover of this
manual and make sure that washer is installed
correctly.
W422I
W391I
W422I
W391I
W376IE0C