ALLIANCE Automaatic washer, Руководство по установке и эксплуатации

Страница: 14 / 32

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
210193 12
Step 4: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp.
Figure 6
Find the instructions, on the following pages, that are
appropriate for your type of drain receptacle (standpipe,
high standpipe, low standpipe, sink, wall, or laundry tub).
Follow these instructions to properly install the drain
hose.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 3.2 cm (1-1/4 inch) outside
diameter drain hose.
Standpipe Installation
Place the adapter into the standpipe.
Remove the beaded tie-down strap from accessories
bag and place around standpipe and drain hose,
approximately 30 cm (12 inches) down from the top of
pipe and tighten strap to hold hose to standpipe. This
will prevent the drain hose from dislodging from drain
receptacle during use.
IMPORTANT: To prevent siphoning, do not place
any ribbed portion of the drain hose into the
standpipe.
Figure 7
TLW873N
1 Retainer Clamp
2 Standpipe Adapter
2
1
TLW874N
1 Ribbed Portion of Drain Hose
2 Standpipe Adapter
3 Tie-Down Strap
4 Standpipe 5.08 cm (2 in.) or 4 cm (1-1/2 in.)
Diameter
91.44 cm (36 in.)
RECOMMENDED
HEIGHT
3
4
1
2
30.48 cm
(12 in.)