ALLIANCE Automaatic washer, Руководство по установке и эксплуатации

Страница: 17 / 32

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
15
210193
Laundry Tub Installation
For this type of installation, the drain hose MUST be
secured to the stationary tub to prevent hose from
dislodging during use. Use the beaded tie-down strap
(supplied in accessories bag) to secure hose.
We recommend leaving the standpipe adapter on the
drain hose for this type installation.
Figure 12
Step 5: Position and Level the Washer
Place rubber feet on all four leveling legs.
Place washer in position on a clean, dry, and
reasonably firm floor. Installing the washer on any type
of carpeting is not recommended.
Loosen locknuts and adjust the two front leveling legs.
Once adjusted, tilt the unit forward on front legs and
lower back down into position to set the rear self-
leveling legs.
Washer must not rock. After washer is at desired height,
tighten locknuts securely against bottom of washer
base. If these locknuts are not tight, washer will not
remain stationary during operation.
Improper installation or flexing of a weak floor will
cause excessive vibration.
Do not slide washer across floor once the leveling legs
have been extended, as legs and base could become
damaged.
Figure 13
TLW878N
1 Tie-Down Strap (Tape if necessary)
TLW878N
1
W179I
1 Rubber Foot
2 Washer Base
3 Level
4 Locknut
5 Leveling Leg
W179I
1
2
5
4
3