QUICKDESIGNER
PLC Direct
••••
181
DL250 Cable
The DL250 has a 6P6C Phone Jack for DirectNET support. The port is marked PORT1 and supports
RS232 at 9600 Baud, Odd parity only. Make sure the baud rate on the DL250 is set to the same setting
as the QuickPanel.
PORT1
DL250
RUN
TERM
RUN
CPU
PWR
BATT
CPU
STOP
PORT2
Use the HMI-CAB-C86 Cable for connecting a QuickPanel to a Direct Logic DL250 PORT1. (See the
drawing in a previous section).
DL430/440
The DL430 and DL440 have 25-pin DirectNET connections. The baud rate is dipswitch selectable and
must match the settings on the QuickPanel.
PWR
CPU
RUN
COM
BATT
I/O
Koyo
Direct
LOGIC
405
D4-430 CPU
RUN
TERM
STOP
110/220VAC
Use the HMI-CAB-C53 Cable for connecting a QuickPanel to a Direct Logic DL430 and DL440. (See
the cable drawing in a previous section).
DL430/440 with D4-DCM Data Communication Module
If the DirectNET port is being used, you can use a D4-DCM module to provide additional DirectNET
protocol. Make sure the dip switches for the communication parameters on the DCM module are the
same as the QuickPanel.
Use the HMI-CAB-C53 Cable for connecting a QuickPanel to a Direct Logic D4-DCM Data
Communication Module. (See the drawing in a previous section).