ALKOTA 3102 Series, Инструкция по безопасности, установке и эксплуатации

Страница: 5 / 50

SAFETY, INSTALLATION, AND OPERATION
ELECTRIC DRIVEN OIL FIRED CLEANER
08-19-04 Z08-02830
MACHINE UNPACKING
ALL CLEANERS ARE CAREFULLY INSPECTED AND
CARTONED TO PROTECT AGAINST SHIPPING
DAMAGE. IF THERE IS DAMAGE OR MISSING PARTS,
THE TRANSPORTATION COMPANY AGENT SHOULD
MAKE A NOTATION TO THAT EFFECT ON THE BILL.
REFER TO THE PARTS LIST IN THIS MANUAL AND
ADVISE WHAT PARTS ARE MISSING OR DAMAGED.
IF AVAILABLE, GIVE THE INVOICE NUMBER ON ALL
ORDER BILLS. THIS PROCEDURE WILL ENABLE
NEEDED PARTS TO BE SHIPPED QUICKLY.
READ ALL Installation, Operation, and Maintenance
instructions before operating the machine
NOTE: Refer to CLEANER MODEL for SERIAL NUMBER
location
NOTE: Dimensions are in inches unless otherwise note
The safety alert symbol.
This symbol is used to identify safety information about
hazards that can result in personal injury.
A signal word (DANGER, WARNING, or CAUTION) is used
with the alert symbol to indicate the likelihood and the
potential severity of injury. In addition, a hazard symbol
may be used to represent the type of hazard
DANGER indicates a hazard which, if not avoided,
will result in death or serious injury.
WARNING indicates a hazard which, if not avoided,
could result in death or serious injury.
CAUTION indicates a hazard which, if not avoided,
might result in minor or moderate injury.
CAUTION , when used without the alert symbol,
indicates a situation that could result in damage to
the equipment.
1. Before operating this machine, read and observe all
safety, unpacking, and operating instructions. Failure
to comply with these instructions could create a
hazardous situation.
2. The operator of this equipment should not operate this
equipment when fatigued or under influence of alcohol
or drugs.
3. The operator of this equipment should be thoroughly
familiar with its operation and trained in the job to be
accomplished.
4. The operator of this equipment should wear protective
face shields and other protective clothing as required
for safe operation.
5. Keep all protective covers and shields in place.
Operating this machine with moving parts could allow
operator or bystander serious injury or even death.
6. Do not operate the machine if any mechanical failure
is noted or suspected. Keep all shields in place.
7. Do not leave this machine unattended when it is
operating.
8. All installations must conform to all applicable local
codes. Contact your electrician, plumber, utility
company or seller for details.
9. If a water leak is found, DO NOT OPERATE THE
MACHINE. Shut off the motor and repair.
10. Follow instructions on how to stop the machine and
bleed pressures quickly. Be thoroughly familiar with
the controls.
11 .. When starting a job, survey the area for possible
hazards and correct before proceeding.
12 . If chemicals are used in conjunction with this
equipment, read and follow the product label
directions.
13 . During normal operation of this machine, HOT
discharges and surfaces may be produced.
14 . Always shut down machine before refueling.
15 . Do not overfill the fuel tank. If any spillage occurs,
clean up immediately and/or neutralize the spill before
attempting to operate the machine.
3
W
ARNING: OPEN FLAME . Do not operate
this machine in an area with combustible
materials. A suitable fire extinguisher
should be available in operating area.
IMPORTANT SAFETY
INSTRUCTIONS
GENERAL SAEFTY
Supersedes 08-15-03 Z08-02830
Read and understand this “OPERATOR’S
MANUAL” and “LABELS ON THE MA-
CHINE” before starting