Alkin W32 Canopy, Инструкция и список запасных частей

Страница: 58 / 121

W 3 2 S E R I E S
H I G H P R E S S U R E B R E A T H I N G A I R C O M P R E S S O R
©ALKIN COMPRESSORS
58
1.
Loosen the nuts (4) that is located in the center
of the top cover.
2. Install the adapter tool (3) which is supplied with
the compressor, onto the cover (5), using the two
bolts (2), that come with the adapter.
3. Use a ratchet tool (1) to loosen the cover (5).
Turn the cover four turns and then remove the
two bolts (2) and the adapter tool (3) from the
cover.
4. Put the two bolts (2) in place to turn the cover
(5) by hand. Turn the cover (5) and remove the
whole assembly from the purifier chamber.
5. Pull the cartridge (7) out of the purifier
chamber(8).
6.
Open the flat end of the cartridge; remove its
contents. Clean the inside of the cartridge by
rinsing, adn throughly drying. by rinsing, adn
throughly drying.
7.
Use the instrcutions supplied with the cartridge
refilling kit to refill the cartridge. Always replace
the chemicals, felt pads and the o-rings with new
materials and parts.
8.
Inspect and clean – if necessary- the inside of the
purifier chamber.
9. Insert the cartridge back into the purifier
chamber. Do not drop. Make sure the cartridge
sits in place properly.
10. Inspect – and replace if necessary- the o ring and
/ or the backing ring on the seal housing.
11. Insert the whole cover in to the purifier chamber.
Install the mountny adapter (3) in place, using the
same bolts (2). Tighten the cover until it is flat
with the purifier chamber top surface.
12. Then loosen it by quarter turn back.
The tool is designed not to let go to tighten beyond
this point but we have seen custumers who lost the
tool, used a makeshift tool that allaws further
4
5
6
2
3
5
6
8
1
2
3
5
6
8
5
8
8
7