Alkin W32 Canopy, Инструкция и список запасных частей

Страница: 11 / 121

W 3 2 S E R I E S
H I G H P R E S S U R E B R E A T H I N G A I R C O M P R E S S O R
©ALKIN COMPRESSORS
11
1.0 GENERAL INFORMATION
1.1 General
1.1.1 General Safety
All ALKIN air compressors are designed and manufactured with equipment and components that allow safe
operation of the compressors. However, it is the user’s responsibility to safely operate and main tain the compressor,
observe the rules and instructions, as well as the local safety codes, to minimize the risk of accidents and injuries.
The following safety precautions are offered only as a guideline, and it is recommended to follow them along with
the local safety codes and regulations.
This compressor should only be operated by those who have been trained to do so, and who have read and
understood the contents of this manual. Failure to do so will increase the risks of accidents and bodily injuries.
Please read also the manual of the equipment (electric, etc.) delivered together with the compressor and perform the
instructions.
Never start this compressor unless it is safe to do so. Do not operate it with known unsafe condition. Tag the
compressor and render it inoperative by disconnecting the power supply, so that others who may not know of the
unsafe condition will not attempt to operate it until the unsafe condition is corrected.
Install, use and operate this air compressor only in full compliance with all pertinent requirements and all relevant
federal, state and local codes and regulations.
Do not modify this compressor and do not use beyond the specified limits (pressure, etc.) and speeds except with
prior written approval of ALKIN.
1.1.2 Safety Tags
Earthing Hot Surface-Do
Not Touch
Can Start
Automatically
Caution: Moving
Parts
Electrical
Hazards
1.1.3 Pressure Release
Run the compressor to see if the safety valves are operating properly or not. See and ensure, safety valves
are discharging the pressure on their adjusted pressure values. Do not open the oil filling plug or any other
connection, tube, hose, fitting, valve etc. when the compressor is running or when it is standing by (in only
automatic start/stop compressors waiting for the pressure switch signal to re-start). Switch off the main electrical
switch, shut off the discharge valve and discharge all pressurized sections before attempting to dismantle such
components.
Section
1