Alkin W32 Canopy, Инструкция и список запасных частей

Страница: 39 / 121

W 3 2 S E R I E S
H I G H P R E S S U R E B R E A T H I N G A I R C O M P R E S S O R
39
W32 CANOPY MODELS HAVE AUTOMATIC BELT TIGHTENING SYSTEM WHICH
DOES NOT REQUIRE PERIODICAL CONTROLS OF BELT TIGHTNESS. PLEASE
CHECK ONLY IF THE BELT(S) ARE IN GOOD CONDITION.
1.11 Storage
If compressor will not be working for a long time for any reason and will be stored during this time, it is
suggested to do the following steps before putting it out of reach in order to keep it in good condition:
1. Start the compressor and run it for app. 15 minutes.
2.
Check if there is any leak on the fittings, hoses, tubes, filters and valves.
3. Open the filling valves and run it for app. 2 minutes at the min. pressure (the pressure which the
priority valve is set at).
4. Open the drain valves and release the pressure inside the compressor.
5.
After the unit is completely depressurised stop the compressor. Close the filling valves and drain.
6. Take out the refillable cartridge inside the purifier housing.
7. Remove the intake filter and disconnect all other connections on the valve heads.
8. Restart the compressor as soon as it cools down. Spray some compressor oil to the valve intakes and
run the compressor for 2-3 minutes in this position.
9. Stop the unit before it gets too warm.
10. Connect the lines to the valve heads which are previously disconnected.
11. Close all the valves and put a cap onto the intake port against the dust and fumes may enter.
12.
Cover the unit with a plastic cover as there will not be any condensation under it. Check the status of
the unit periodically if you can and clean it if it’s necessary.
13. The compressor should be stored in a dry, safe and sheltered indoor place.
Note I
IF THE COMPRESSOR WILL NOT BE WORKING BUT STORED FOR A LONG
TIME AND YOU CAN NOT DO PRECAUTIONS MENTIONED ABOVE, YOU
NEED TO OPERATE THE COMPRESSOR AT LEAST TWICE A MONTH FOR 1
HOUR TO LUBRICATE INNER PARTS. IN FAILURE TO DO SO, THE
OXIDIZATION MAY ARISE ON THE INNER PARTS AND CAUSE TROUBLE
FOR THE OPERATOR AND COMPRESSOR DURING NEXT START
.