9
Figure 10d
Figure 10e
CLEANING THE CHAMBER PIPE
Clean the chamber pipe every 10-15 days.
When the firebox is taken out, clean the dirty sides of the chamber with a brush.
Clean the inside of all boiler exchanger pipes located on the upper side of the exchanger (Figure 11a) by moving the
brush up and down. It has 11 pipes. They are not visible from the front side. Find them with your hands.
Vacuum clean the interior of the chamber (Figure 11b).
Return the cleaned firebox on the firebox support and fix it with the handrail on the firebox support by lowering the
firebox handrail (forward, down) to the lower position (so that you hear jumps when fixing the handrail) (Figure 11c).
Take care that the non-asbestos tape on the underside of the firebox stays in its place and is not damaged. If damaged,
replace it with a new one and seal it with high temperature resistant silicone (approximately 1000 ° C).
Figure 11a
Figure 11b
Figure 11c
CLEANING THE UPPER ASHTRAY AND SPACE AROUND THE UPPER A SHTRAY
Clean the upper ashtray every 3-4 days.
Open the lower exterior door of the boiler (Figure 12a).
Unblock the fixed ashtray with both hands by moving the ashtray handrail forward and by lowering it (Figure 12b).
Take the upper ashtray out and pour the ashes into the garbage bin.
Then clean the ashtray and the space around the ashtray (in the boiler ) with the vacuum cleaner (Figure 12c).
Figure 12a
Figure 12b
Figure 12c
CLEANING THE FIREBOX SUPPORT BOTTOM
When the upper ashtray is taken out, it is necessary to clean the bottom of the firebox support. It is located in the upper
part of the space around the upper ashtray.
Clean it every 3-4 days.
Loosen the two butterfly nuts and remove the lid (Figure 13a).
Use the vacuum cleaner through the rectangular opening to vacuum the bottom of the firebox support (Figure 13b).
Return the lid in its place and tighten with the butterfly nuts (Figure 13c).
Make sure that the non-asbestos tape on the underside of the lid stays in its place and that it does not get damaged. If
damaged, replace it with a new one and seal it with high temperature resistant silicone (approximately 1000 ° C).
In the end, return the upper ashtray and fix it with the ashtray handrail by moving the ashtray handrail upwards and
then back (Figure 12b).
Make sure that the non-asbestos tape on the underside of the ashtray stays in its place and that it does not get
damaged. If damaged, replace it with a new one and seal it with high temperature resistant silicone (approximately 1000 ° C).
Figure 13a
Figure 13b
Figure 13c
