AE–1800 Instruction Manual
Customizing Operation via Menu System
4.13.3.
Checking Test Results
Figure 4-37 Results of Self–Diagnostic Test – Example
The function will be
terminated automatically just
after completion of the keypad
dimmer lamp test (
TESTING
KEYPAD LAMPS
on the test
report). The test report window
will remain to allow the user to
check the tests results. The
figure at right shows an
example of the test report
showing the results of the self–
diagnostic tests.
The result of each check will be available in one of the following indications:
・
O K
:
Tested hardware is functioning normally (for test items 1, 2 and 3).
・
FAI LE D
:
Malfunction of tested hardware is detected (for test items 1, 2 and 3).
If this indication shows up, see section 5 (User–Level Trouble–
shooting
) for actions to be taken, or contact your dealer for assistance.
NOTE: If the receiver test result is “
FAILED
,” check to be sure that the
unit has been turned on for at least 30 minutes before starting the test.
This warm–up period is necessary for the internal test oscillators to
become stable. The “
FAILED
” indication should not be immediately
interpreted as a sign of receiver malfunction if the unit was tested
shortly after power–up.
・
COM P LE TE
: Test is completed (for test items 4 and 5). The user should check
whether the tested hardware component functioned correctly.
(1) Result of Audible Alarm Test
Execution of the test “
4:TESTING ALARM
” checks the buzzer function of the
audible alarm circuit. On successful completion of the test, the buzzer should sound
three slow beeps. If no sound is heard, see section 5 (User–Level Troubleshooting)
for actions to be taken, or contact your dealer for assistance.
(2) Result of Keypad Backlighting Lamp Test
Execution of the test “
5:TESTING KEYPAD LAMPS
” checks the light–emitting
diodes (LEDs) that illuminate the keys and their control circuit. All keys should be
lit blinking at the maximum level during the test. If no key is lit or if some of the
keys remain extinguished, see section 5 (User–Level Troubleshooting) for actions to
be taken, or contact your dealer for assistance.
This test result should be checked in a dark environment for ease of checking.
8: START SELF–DIAGNOSTIC TESTS
SELF–DIAGNOSTIC TEST REPORT
1: TESTING RECEIVERS
1ST RCVR
(
(518KHZ)
((518KH
OK
0 1 2 3 4 5 6 7 8 9 ( ) . , = ?
ABCDEFGHIJKLMNOPQRSTUVWXYZ
2ND RCVR (490KHZ )
OK
0 1 2 3 4 5 6 7 8 9 ( ) . , = ?
ABCDEFGHIJKLMNOPQRSTUVWXYZ
2: TESTING ROM
OK
3: TESTING RAM
OK
4: TESTING ALARM
COMPLETE
5: TESTING KEYPAD LAMPS
COMPLETE
SOFTWARE VER. 1.0 REV_1.1A1
DATE OCT 06, 2007
