AE–1800 Instruction Manual
Customizing Operation via Menu System
4.12.4.4.
Selecting Parameters for I / O DATA
Port
The parameters for the
I / O DATA
port are initially set as follows:
･
Data Bits: 8 bits
･
Stop Bits: 1 bit
･
Parity:
Odd parity
･
Bit Rate: 4800 baud
NOTES:
(1) The message outputs available from the
I / O DATA
port are the same as those
from the printer port (
RS–232C
).
(2) If you wish to connect a serial printer other than the
PR–900
to the
I / O DATA
port, be
sure to turn off its hardware flow control and set it to “X–ON/X–OFF,” if available, or
an erratic printout can result.
The current parameter values can be checked by selecting “
3:I / O DATA
” on the
SET BIT
FORMAT & RATE
submenu, as shown below.
Figure 4-35 Checking Current Parameters for
I / O DATA
Port
Each parameter value can be changed using
/
and
/
in the same man–
ner as in the example given in paragraph 4.12.4.2.
Be sure to press
after selecting the desired value.
S Y S T E M M E N U
1:
MAKE DISPLAY SETTINGS
2: SELECT 2ND RECEIVER FREQUENCIES
3: TURN ON / OFF KEYPRESS BEEP
4: MAKE SEL / REJ SETTINGS
5: SEARCH FOR STORED MESSAGES
6. SELECT OUTPUT MESSAGES
7. SET OUTPUT PORTS
8. START SELF–DIAGNOSTIC TESTS
9: TURN ON / OFF MESSAGE ALARM
0. RESET TO FACTORY DEFAULTS
7: SET OUTPUT PORTS
1: S E T PORTS ON / OFF
2: SELECT PROTOCOLS
3: S E T B I T FORMAT & RATE
3: SET BIT FORMAT & RATE
1: RS– 232C
2: RS– 422
3: I / O DATA
3: I / O DATA
1: DATA BITS
I 7
I
8
I
2: STOP BITS i
1
i 2
3: PARITY
i
ODD
i NONE
4: BIT RATE
0.11 I
4.8
I 9.6 19.2 38.4
