Alcatel SPEED TOUCH 710, Руководство пользователя

Страница: 108 / 254

Decision procedure
11 Configuration and Use - CIP & IP Routing
108 / 254
3EC 17605 AAAA TCZZA Ed. 02
11.2.1 General CIP Configuration Procedure
Due to the many decisions that must be made in order to be able
to configure the AST710 to be an active member of a LIS, the
procedure to be followed is best retrieved from the following
decision table:
Step Decision and/or Action See
1
Answer Action and Description
Yes
No You can create the LIS with IP parameters of
your choice. See topic 'Creating a New LIS' of
subsection 11.2.2.
In case you create a new LIS, you must create
the LIS at both end of the DSL connection, i.e.
at the local, and on the remote side.
You must retrieve the LIS IP parameters to
which your local configuration must adhere to.
See topic 'Configuration for an Existing LIS' of
subsection 11.2.2.
Are you configuring the AST710 for an existing LIS ?
11.2.2
2 Retrieve the appropriate LIS parameters, and check on
which VCs (identifiable by their VPI/VCI values) your service
provider enabled the CIP packet service.
11.2.2
3 If needed, create a CIP phonebook entry, i.e. a CIP PVC, in
the 'Phonebook' page.
11.4
4 Is the remote access router a RFC1577/RFC2225 compliant device,
e.g. another AST710 ?
Answer Action and Description
Yes
No
The remote access router will not respond to
'InATMARP' requests submitted by the AST710 ,
thus the CIP PVC must be explicitly assigned to
the CIP member.
The remote access router will respond to
'InATMARP' requests, thus the CIP PVC can be
implicitly assigned to the CIP member.
See
11.2.3
11.2.4
5 If needed, create a CIP member in the 'CIP Interfaces' table
of the 'CIP' page.
11.4
6 Add appropriate IP routes to the AST710 via the 'IP route'
table on the 'Routing' page.
11.2.6
7 Add appropriate IP routes in you PC(s). 11.2.6