Alcatel SPEED TOUCH 710, Руководство пользователя

Страница: 182 / 254

The 'Interface
Configurations' table
Interface configuration
15 Voice - Voice over DSL
182 / 254
3EC 17605 AAAA TCZZA Ed. 02
The following figure shows the 'Interface Configuration' tables:
Per default all VoDSL ports are configured for Loop start. However,
the 'Voice Interface Settings' table allows you to configure Ground
or Loop start condition per VoDSL port.
Proceed as follows:
1. Browse to the 'VoDSL' page.
2. Click next to the VoDSL port you want to change the start
condition for.
Note : The VoDSL ports are identified as follows: VoDSL port 1 = voice0,
VoDSL port 2 = voice1, etc.
3. Check ' Ground start ' ( ) in case the VoDSL port connects to
a P(A)BX which uses Ground start.
4. Click and to finish the procedure.
In case one or more VoDSL ports are configured for Ground start,
both AST710 and P(A)BX(s) must use the same common signal
ground. Therefore, you must wire the Sig Gnd port on the back
panel of the AST710 to the P(A)BX(s) used by the VoDSL port(s).
See section 4.3 for more information.
CAUTION