Alcatel-Lucent 7710 SR OS, Руководство по настройке интерфейса

Страница: 294 / 436

Configuration Commands
Page 294 7710 SR OS Interface Configuration Guide
LAG Commands
lag
Syntax [ no ] lag [ lag-id ]
Context config
Description
This command creates the context for configuring Link Aggregation Group (LAG) attributes.
A LAG can be used to group up to 8 ports into one logical link. The aggregation of multiple physical
links allows for load sharing and offers seamless redundancy. If one of the links fails, traffic will be
redistributed over the remaining links. Up to 8 links can be supported in a single LAG, up to 64 LAGs
can be configured on a node.
NOTE: All ports in a LAG group must have autonegotiation set to Limited or Disabled.
There are three possible settings for autonegotiation:
• “on” or enabled with full port capabilities advertised
• “off” or disabled where there is no autonegotiation advertisements
• “limited” where a single speed/duplex is advertised.
When autonegotiation is enabled on a port, the link attempts to automatically negotiate the link speed
and duplex parameters. If autonegotiation is enabled, the configured duplex and speed parameters are
ignored.
When autonegotiation is disabled on a port, the port does not attempt to autonegotiate and will only
operate at the
speed and duplex settings configured for the port. Note that disabling autonegotiation
on gigabit ports is not allowed as the IEEE 802.3 specification for gigabit Ethernet requires
autonegotiation be enabled for far end fault indication.
If the autonegotiate limited keyword option is specified the port will autonegotate but will only
advertise a specific speed and duplex. The speed and duplex advertised are the speed and duplex
settings configured for the port. One use for limited mode is for multispeed gigabit ports to force
gigabit operation while keeping autonegotiation is enabled for compliance with IEEE 801.3.
7710 SR OS requires that autonegotiation be disabled or limited for ports in a Link Aggregation
Group to guarantee a specific port speed.
The no form of this command deletes the LAG from the configuration. Deleting a LAG can only be
performed while the LAG is administratively shut down. Any dependencies such as IP-Interfaces
configurations must be removed from the configuration before issuing the
no lag command.
Default No LAGs are defined.
Parameters lag-id — The LAG identifier, expressed as a decimal integer.
Values 1 — 64