8
First Time Power Up
When powered for the first time (or the "Erase All Programming" procedure performed) but before it is
programmed by the wireless network Gateway, the PL6600 / ETPLNRX will remain unlocked, and will not
lock until the first valid proximity card is presented to the lock.
1. Unpack the lock from its factory packaging.
2. For models with a replaceable battery pack, install fresh batteries with attention to the correct polar-
ity as indicated inside the plastic battery pack housing. Do not connect the batteries yet.
3. With battery power disconnected, short the two white wires (
Remote Input
wires) together for 10
seconds to ensure discharge of all capacitors. After 10 seconds, remove the short.
4. Connect the battery pack. The lock will immediately sound 3 short beeps (if these 3 beeps are not
heard, then begin this procedure again at step 3).
Within 3 seconds, press and hold down the
outside door handle
until the lock sounds more slow beeps (1 beep for every second it takes to
clear the memory). The outside door handle may be released when these beeps are first heard.
5. After 2 rapid beeps are heard and 2 green LED flashes are seen, the lock is ready for program-
ming.
Wiring
See the installation instructions for additional information.
Batteries:
Use only four 1.5 volt Alkaline size-C batteries or an Alarm Lock pre-wired sealed battery pack.
External Power:
Red / Black wires - External 7.5 VDC Power Source must be used for operation without batteries.
Remote Input:
White / White wires - These two white "Remote Input" wires can be programmed as a "Remote Release" or
for "Door Monitoring" (programming is performed after lock is installed on the door): For "Remote Release",
wire a normally open contact to wires (white and white) and momentarily close to allow PL6600 / ETPLNRX
lock to unlock. When "Door Monitoring" is desired, connect these two white wires to the supplied Door Con-
tact wires (when the door is closed the contacts are also "closed").
NOTE: These two white "Remote In-
put" wires are enabled from the factory
.
Relay:
COM-Orange; N/O-Green; N/C-Yellow
Battery Replacement
When a valid proximity card is presented to the lock and the batteries are weak, the lock will beep for the
duration of the "Pass Time" programmed ("Pass Time" is the duration the lock remains unlocked after ac-
cess is granted). For models with a replacable battery pack, use four (4) C-size 1.5 volt alkaline batteries.
For models with a sealed battery pack, contact your Alarm Lock dealer for a replacement battery pack.
Always replace weak batteries as soon as possible.
1. At the back of the lock, remove the lock housing screw and remove the cover.
2. Pull out the battery pack and quickly replace all 4 batteries - within 1 minute. For models with the
sealed battery pack, simply unplug the old battery pack and plug in the new battery pack.
3. If you
do not
hear the 3 beeps when power is re-applied, all programming and settings have been
retained, and the lock is ready for use. Go to step 5.
4. If you
do
hear 3 beeps when power is re-applied, wait 15 seconds for the LED to flash red 7 times
and 7 beeps will sound. Re-set the clock using DL-Windows.
5. Replace the back cover and tighten the screw.
Содержание Networx ETPLNRX
Страница 15: ...15 NOTES ...
