Alarm Lock Networx ETPLNRX, Инструкция по программированию

Страница: 9 / 16

9
Erase All Programming
Restore the "out of box" factory condition.
1. At the back of the lock, remove the screw at the bottom of the lock housing and remove the cover.
2. Disconnect the battery pack connector.
3. With battery power disconnected, short the two white wires (
Remote Input wires) together for 10 seconds to
ensure discharge of all capacitors. After 10 seconds, remove the short.
4. Re-connect the battery pack. The lock will immediately sound 3 short beeps (if these 3 beeps are not heard,
then restart at step 3). Within 3 seconds, hold down the outside handle.
5. The lock will then sound more slow beeps, 1 beep for every second it takes to clear the memory. Release the
handle.
6. Lock is ready for programming after 2 rapid beeps are heard and 2 green LED flashes are seen.
Verifying Proximity Card and Keyfob Access
Test by simply presenting a valid proximity card or fob to the reader in front of the lock.
VALID CARD - Green LED flashes, the sounder beeps several times and the PL6600/ETPLNRX unlocks.
INVALID CARD - Red LED flashes several times and the sounder beeps several times.
Testing the Cards Entered
Use when re-applying power to a lock already in use (you wish to retain the Lock Program), such as when moving
an existing lock to a new door. The lock must be dismantled and powered down for an extended period.
1. Disconnect battery pack connector.
2. With battery power disconnected, short the two white wires (
Remote Input wires) together for 10 seconds to
ensure discharge of all capacitors.
3. Without touching or turning the handle , re-connect the battery pack (lock will sound 3 short beeps). If
these 3 beeps are not heard, then restart at step 1. The lock will perform several self tests; when complete, 7
beeps and LED flashes will sound. The lock is now ready for use.
Power Up--Retain Existing Programming
ACTIVITY LED SOUNDER COMMENTS
Access Granted or
Remote Release
2 green flashes 2 Beeps
Invalid Card / Fob 7 red flashes 7 Beeps
An invalid proximity card / fob does not exist in the Lock
Program memory.
Valid but Disabled
Card / Fob
1 green, 4 red flashes 1 Long, 5 Short Beeps A proximity card / fob exists in the firmware, but is disabled.
Emergency Commands
are in effect
1 red flash every two
seconds
-- --
Low Battery
See page 8 ("Battery Replacement) before changing
batteries. ("Pass Time" is the duration the lock remains
unlocked after access is granted).
Red LED and Sounder turn on steady for the
duration of the "Pass Time".
Door Ajar
1 red flash once every
second (continues for xx
seconds)
-- --
Forced Door Detection
(door "kick-in")
--
Steady tone
for xx seconds
--
LED and Sounder Indicators
With a fully charged battery, the LED and sounder provide visual and audible feedback as follows: