Akron EXG 400 X, Руководство пользователя

Страница: 42 / 106

42
EXG 400 X GRAIN BAG UNLOADER
7-d. Lubrication
7-e. Prevention of Wear on Flexible Pipes
Take into account the following items for a better
use and care of the flexible pipes included in the
machine:
·
Visually inspect the hydraulic circuit hoses and
accessories related to the flow gate operation
and to the folding/unfolding of the auger tube.
They should not have leakages. Keep them from
touching sharp objects. Do not tread on hoses
and keep them from being strangled.
·
Check that the helical tape covering the
hydraulic circuit is in good condition, since it is
meant to prevent fluid from hitting the operator if
a pipe brakes.
WARNING: Avoid leakage of fluids under
pressure.
IMPORTANT: To grease objects that are
at a certain height, use a ladder or any
other auxiliary device.
7-f.Tire Change
Complete the following steps:
1) Slightly loosen the wheel nuts.
2) Lift the machine using a mechanical or
hydraulics jackes.
3) Once the
grain extractor
has been lifted,
install the assembled wheel and the five wheel
nuts (Parts List # 8).
Tighten the nuts using a 21-mm hexagonal
wrench until a final tightening torque of 9kgm
=90 Nm = 65 lbs. pie.
Part or assembly Location
Lubrication
frequency
Drive Chain – front
and rear
Driveshaft Every 50 hours (*)
Sleeve
Vertical auger hinge
End of the hydraulic cylinder operating the vertical auger.
Every 50 hours (*)
Bearings On the upper horizontal drive shaft - Rear part Every 100 hours (*)
DRIVE GEARBOX
Reduction Gearbox
Inside the chassis Every 300 hours (*)
Wheel hub Axle Every 300 hours (*)
The use of lithium grease # 2 NLGI 2 is recommended for the lubrication ports and SAE 80W-90 oil is
recommended for the gearboxes.
(*) Check chain tension every time chains are lubricated, and correct in any case as necessary.
It is recommended adjusting the chain after unloading the first two bags.