Akron EXG 400 X, Руководство пользователя

Страница: 29 / 106

29
EXG 400 X GRAIN BAG UNLOADER
WARNING: Ceck that the cutting blade
cover protects the blade while the
machine is not operating.
5-g. Final Adjustments on the Machine
First of all, the cardan shaft should not be
operated before the grain bag is fixed to the
Otherwise, the augers would start moving and
the grain bag could get entangled in them.
Completely close the flow control valve, and
then open it half a turn, that is, 180º.
1) Turn the roll using the tractor’s hydraulic
system until the roll teeth reach the position
shown in the figure 5.13
2) To fix the bag to the roll, both the upper and
lower sides of the bag should easily reach the
whole breadth of the roll at the height of its teeth.
Figure 5.13 - Location of the roll teeth
3) Pierce both sides of the end of the grain bag
with each of the roll teeth, as shown in figure
5.14.
Figure 5.14 – Bag Perforation
Figure 5.15 secure the bag on the roller teeth.
4) Check once again that the machine’s cutting
blade is aligned with the cut previously made on
the top of the bag.If the cut on the grain bag
were not continued normally, the extractor would
be subjected to excessive efforts and the grain
bag would run the risk of being torn.
If the cutting blade stops cutting, a small
transversal (figure 5.16) cut must be made on
the grain bag in order to align it with the blade by
means of a longitudinal cut as shown in the
following figure 5.17.
Flow Control Valve
figure 5.11 Close
(clockwide)
Figure 5.12 Open
1/2 Turn
(counterclockwide)
Upper side of
the grain bag
Tractor’s
side
Lower side of
the grain bag
Roll
Teeth
Piece the
grain bag
Tractor’s
side
Tractor’s
side
Grain bag
TRANSVERSAL
CUT
CUTTING
BLADE
GRAIN BAG
Figure 5.16 - Transversal cut
PREPARATION AND
SETUP