- 30 -
Troubleshooting
Should your DVD player develop a problem, please check below before requesting
service:
* Check if the power cord has been properly connected to the power outlet.
* Check if the main power has been switched on.
* No disc, load disc.
* Disc has been loaded upside down. Place the disc with the label side up.
* The
region code of disc does not match to the player.
* Disc is not correct type for the player.
* Disc is damaged or dirty, clean the disc or try another disc.
* Moisture may be condensed inside the player, Remove the disc and
leave the unit power on for one or two hours.
* Check if the TV set has power on, use TV remote to select A/V
signal for DVD rather than broadcast.
* Check if the system connection is proper and secure.
* Check if the connection cables are damaged.
* Clean the disc.
* The disc is dirty or damaged. Clean the disc or try another disc.
* Reset the color system of the player or the TV set.
* Try to direct the player to the TV set instead of via other components,
such as a VCR.
* Select the screen format from the player s SETUP MENU, see (SETUP
MENU) of this manual.
* Select the screen format from DVD disc menu.
* Press and hold the power button on the front panel until the player
power off. Or switch the main power switch on the rear panel off.
Power on again, the player will be reset.
* Should the player still develop a malfunction, unplug the player for 30
minutes. After 30 minutes, power on the player and the restore
function should reset the player.
* Some discs are programmed that do not allow users to SKIP or
SEARCH at some sections, especially at the beginning WARNING
section.
* Single Chapter disc cannot apply SKIP function.
No Power
Does not play
No Picture
Picture noise/
distorted
Picture not full
screen
Malfunction
Cannot SKIP or
SEARCH
Symptom Check and Action
Содержание QX-3700DV
Страница 34: ...AKAI ELECTRIC CO LTD JAPAN www akai com ...