The Hood visor is used to protect the camera and to avoid false alarms of the masking
detection system in heavy rain or snow.
Maintenance
Check the functioning of the detector on a regular basis. The optimal frequency
of checks is once every three months. Clean the detector body from dust,
cobwebs, and other contaminants as they emerge. Use a soft dry cloth suitable
for equipment care.
Do not use substances that contain alcohol, acetone, gasoline or other active
solvents to clean the detector. Wipe the lens gently as scratches may impair the
detector sensitivity.
The pre-installed batteries provide up to 3 years of battery life at the rate of 1
alarm per day with the standard Jeweller settings (ping period — 36 seconds). If
the detector batteries are nearly depleted, the security system will send an
appropriate notification, and the LED will light up and go out gradually when the
detector detects any movement or if the tamper triggers.
MotionCam Outdoor can work up to 2 months after the low battery signal.
However, we recommend that you replace the batteries immediately upon
notification. It is advisable to use lithium batteries. They have a large capacity
and are less affected by temperatures.
7. Attach MotionCam Outdoor to the mounting plate, wait for the calibration to
complete, and tighten the screw at the bottom of the body. The screw is
needed for more reliable fastening and protection of the detector from quick
dismantling.
8. Once the detector is attached firmly to SmartBracket, the LED will flash to
indicate that the tamper has been triggered. If the LED does not light up
after the device is attached to SmartBracket, check the tamper status in the
Ajax app and then make sure the panel is firmly attached.
How long Ajax devices operate on batteries, and what affects this
Содержание MotionCam
Страница 32: ......
