Wings Signal Strength Test
Switches the detector to the Wings signal
strength test mode.
The test checks the signal strength between the
hub and the detector at Wings frequencies to
determine the optimum installation place
Signal Attenuation Test
Switches the detector to the signal attenuation
test mode.
The test decreases or increases the radio
transmitter power to simulate a change in the
environment to check the stability of
communication between the detector and the
hub
Temporary Deactivation
Allows the user to disconnect the device
without removing it from the system. Two
options are available:
The system can also automatically deactivate
devices when the set number of alarms is
exceeded
Lower sensor of the detector
Masking sensors
All motion sensors together
Entirely — the device will not execute
commands or participate in automation
scenarios. The system will ignore device
alarms and other notifications
Lid only — the system will ignore
notifications about the triggering of the
device tamper only
Содержание MotionCam
Страница 32: ......
