FS2 Frame Synchronizer/Converter v3.0 37 www.aja.com
Holding down any button enables coarse adjustment of the current parameter
using the ADJUST knob.
SELECT and ADJUST Knobs
The SELECT and ADJUST knobs operate as follows:
• Scroll menus—Turn SELECT to scroll menus within the selected Menu Group.
• Edit a menu—Stop SELECT on a menu to select it for editing. If multiple values
may be edited, such as an IP address, push ADJUST momentarily and then turn
the SELECT knob to scroll through the values and select one for editing. The
value blinks to indicate it is the one selected.
• Change a value—Turn ADJUST to change a value, number, or letter. Turning
ADJUST forward (clockwise) or backward (counterclockwise) changes the
value up or down, respectively. When you reach the end of the available
values, the list starts over again at the beginning.
• Make a coarse adjustment—Holding down a Menu Group button enables
coarse adjustment using ADJUST for wide-ranging values.
• Undo a change—Push SELECT during value editing to abort the edit and
restore a value to its previous setting, if it has not already been saved.
• Set factory default value—Push and hold ADJUST for 4 seconds to set the
parameter to its factory default value.
• Save changes—Parameter value changes are saved within a few seconds. For
multiple values, such as IP addresses, push ADJUST momentarily (less than 4
seconds) to save or take parameter changes.
Menu Operation Examples
The following examples demonstrate typical menu operation.
Status Pages
These steps explain how to surf the STATUS menus.
1. Press the STATUS Menu Group button.
2. Turn the SELECT knob forward and backward to display the Status pages.
The display scrolls through the pages as you turn the knob. The Status
displays simply show the status of important FS2 operational parameters.
Press STATUS button and
turn SELECT knob to scroll
through Status pages.
Settings cannot be changed.
SELECT ADJUST
IN1 SDI1 1080i59
OUT1 525i59 AES/EBU
IN2 SDI2 1080i59
OUT2 525i59 AES/EBU
Current Settings
Current Settings
Current Settings
Current Settings
Simple Menus: Config Format Alarm Filters
These steps explain how to surf and change simple menus, such as the Power
Supply Alarm Filters.
1. Press the CONFIG Menu Group button.