Airxcel Maxxair 44000 Series, Инструкции по установке, эксплуатации и обслуживанию

Страница: 10 / 88

10
MULTI Button:
This button is used for temperature units setting and blue tooth pairing.
MULTI Button
Actions
Function Available Initial Display Follow through actions***
Press 2 times
Configures
temperature unit
•
Shows CEL or
FAH**
Press UP or DOWN on the
remote to toggle between
°C and °F
Press 3 times
Sends Bluetooth
ID to receiver
•
Shows Bluetooth ID
XX:XX:XX
Press any key to send the
Bluetooth ID to the User
Interface board
** Bluetooth ID display on remote controller shows CEL or FAH
***After the follow through actions have taken place, pressing MULTI again would revert the display
to normal.
v. SELECTING THE MODE OF
OPERATION
The heat pump has four modes of operation
–
Cooling, Heating, Auto-Changeover, and Fan.
To select the desired operation, press the
MODE button. Then use the UP or DOWN
button to select the set point temperature.
Select the desired fan speed by pressing the
FAN button. To advance to the next mode,
press the MODE button.
COOLING : The unit will operate in the cooling
mode to maintain the set point temperature. In
the cooling mode, six fan selections are
available: High speed continuous, Medium
speed continuous, Low speed continuous,
Auto High, Auto Medium, Auto Low. In Auto,
the Fan cycles on & off with the compressor.
Use the Fan button to select the desired
setting. To advance to the Heating mode,
press the
MODE button.
HEATING : The unit will operate in the heating
mode to maintain the set point temperature. In
the heating mode, three fan selections are
available: High speed continuous, Medium
speed continuous, Low speed continuous. Use
the fan button to select the desired setting. To
advance to the Auto mode, press the
MODE
button.
AUTO : The unit will automatically heat and
cool, depending on the set point temperature.
Use the UP & DOWN buttons to select the
desired set point temperature. In the AUTO
mode, the fan speed is selected automatically.
To advance to the Fan mode, press the
MODE button.
FAN : The indoor fan can operate to circulate
air without the compressor running. In the Fan
Mode, three fan selections are available: High
speed continuous, Medium speed continuous,
or Low speed continuous. Use the
FAN button
to select.
vi. CEILING ASSEMBLY CONTROL PAD
The ceiling assembly has a two-color LED to
indicate if the unit is in Cooling or Heating
mode and a manual override button which can
be used if the remote controller is lost or
malfunctions. The manual override button will
change between heating and cooling by
pressing the button.