Airspan AirSynergy3, Руководство по установке

Страница: 6 / 65

AirSynergy3 Equipment Installation Guide
Page 6 | Commercial in Confidence SYN-UG-018
Figure 29
– AirSynergy drops down into slots at the top of pole-mount plate
.......................... 27
Figure 30
– Gently lift the AirSynergy body until the bottom studs engage in the bottom slots
.............................................................................................................................................................. 27
Figure 31
– AirSynergy body engaged in the bottom slots
............................................................ 27
Figure 32
– AirSynergy downtilt adjustment
.................................................................................... 28
Figure 33
– Tighten flange nuts (4 positions) once the required mounting angle is set
............. 28
Figure 34
– AirSynergy attachment of earthing cable
..................................................................... 29
Figure 35
– Attach earth cable to pole
............................................................................................... 29
Figure 36
– Connecting the antenna RF cables
.............................................................................. 31
Figure 37
– AirSynergy Front mount antenna connections – applying self -amalgamating tape
.............................................................................................................................................................. 31
Figure 38
– AirSynergy antenna connections – applying PVC tape
............................................. 32
Figure 39
– Attach the power cable to the AirSynergy
................................................................... 32
Figure 40
– Tools required to connect the PSU
............................................................................... 33
Figure 41
– AirSynergy3 power and network cable overview diagram
........................................ 34
Figure 42
– Preparing the end of the drop cable
............................................................................. 35
Figure 43
– Water proof power connector with the 2 halves separated
........................................ 35
Figure 44
– Waterproof connector dis-assembled ready for installation on the cables
............. 35
Figure 45
– Cable gland and connector body positioned on the drop cable.
............................... 36
Figure 46
– Fit the cable ends into the connector and secure
....................................................... 36
Figure 47
– Male part of connector with both drop cable wires fitted
........................................... 36
Figure 48
– Connector contact position markings
.......................................................................... 37
Figure 49
– Assemble the connector and tighten the gland
........................................................... 37
Figure 50
– Prepare the ends of the PSU cable and thread the connector part over the cable
.. 37
Figure 51
– Female part of connector with both PSU cable wires fitted
....................................... 38
Figure 52
– Assemble the connector ad tighten the sealing gland
.............................................. 38
Figure 53
– Connector parts joined together
.................................................................................. 38
Figure 54 - High power (240W) PSU showing the Mains and low voltage connections .............. 39
Figure 55
– Standard power (100W) PSU
.......................................................................................... 39
Figure 56
– Fix the PSU into position using self tapping screws
................................................. 39